LCD1602控制總線模式

源程序如下，可以對比時序方式，理解總線的操作方法。#includereg51.h>//#includeabsacc.h>#define uchar  unsigned char#define uint   unsigned int #define busy  0x80uchar  xdata  LCMWriteCOM   _at_ 0x80ff;  //寫指令寄存器uchar  xdata  LCMReadCOM    _at_ 0xa0ff ;  //讀指令寄存器uchar  xdata  LCMWriteData  _at_ 0xc0ff ; //寫數據寄存器uchar  xdata  LCMReadData   _at_ 0xe0ff ;  //讀數據寄存器uchar  data   LCMLineOne[16]="Welcome";  //第一行顯示的數據uchar  data   LCMLineTwo[16]="Happy day";  //第二行顯示的數據void Delayms(uchar  ms){uchar  i,j;for(i=0;ims;i++)for(j=0;j57;j++);}//寫指令寄存器void LCMWriteC(uchar  COMData){ uchar LCMStatus;do{LCMStatus=(LCMReadCOMbusy); }while(LCMStatus!=0);LCMWriteCOM=COMData;}//讀指令寄存器uchar LCMReadC(){uchar LCMStatus;do{LCMStatus=(LCMReadCOMbusy); }while(LCMStatus!=0);LCMStatus=LCMReadCOM;return(LCMStatus);}//讀數據寄存器uchar LCMReadD(uchar addr){uchar LCMStatus;do{LCMStatus=(LCMReadCOMbusy); }while(LCMStatus!=0);LCMWriteC(0x80+addr);LCMStatus=LCMReadData;return(LCMStatus);}//寫數據寄存器帶地址void LCMWriteDAdd(uchar addr,uchar LCMData){uchar LCMStatus;do{LCMStatus=(LCMReadCOMbusy); }while(LCMStatus!=0);LCMWriteC(0x80+addr);LCMWriteData=LCMData;}//寫數據寄存器無地址void LCMWriteD(uchar LCMData){uchar LCMStatus;do{LCMStatus=(LCMReadCOMbusy); }while(LCMStatus!=0);LCMWriteData=LCMData;}//初始化void LCMInit(void){ Delayms(15);LCMWriteCOM=0x38;Delayms(5);LCMWriteCOM=0x38;Delayms(5);LCMWriteCOM=0x38;Delayms(5);LCMWriteC(0x38);LCMWriteC(0x08);LCMWriteC(0x01);LCMWriteC(0x06);LCMWriteC(0x0c);}main(){ uchar i;LCMInit();while(1){ LCMWriteC(0x80);      //第一行開始地址for(i=0;i16;i++)LCMWriteD(LCMLineOne[i]);LCMWriteC(0x80+0x40);   //第二行開始地址for(i=0;i16;i++)LCMWriteD(LCMLineTwo[i]);}}