STM32F051R8T6的RCC配置

void RCC_Configuration(void)
{
ErrorStatus HSEStartUpStatus;
RCC_DeInit();
RCC_HSEConfig(RCC_HSE_ON); //RCC_HSE_ON--HSE晶振打開(ON)
HSEStartUpStatus = RCC_WaitForHSEStartUp();
if(HSEStartUpStatus == SUCCESS) //SUCCESS：HSE晶振穩定且就緒
{
FLASH_SetLatency(FLASH_Latency_1); //FLASH_Latency_1 1延時周期
FLASH_PrefetchBufferCmd(ENABLE); // 預取指緩存使能

/* PLL configuration: pllclk= HSE * 6 = 48 MHz */
RCC_PREDIV1Config(RCC_PREDIV1_Div1);
RCC_PLLConfig(RCC_PLLSource_PREDIV1, RCC_PLLMul_6);

RCC_HCLKConfig(RCC_SYSCLK_Div1); //RCC_SYSCLK_Div1--AHB時鐘 HCLK= SYSCLK(48)系統時鐘
RCC_PCLKConfig(RCC_HCLK_Div1); //PCLK = HCLK = 48

RCC_PLLCmd(ENABLE);
while(RCC_GetFlagStatus(RCC_FLAG_PLLRDY) == RESET){}

RCC_SYSCLKConfig(RCC_SYSCLKSource_PLLCLK); //選擇PLL作為sysclk系統時鐘 SYSCLK = PLLCLK
while(RCC_GetSYSCLKSource() != 0x08){} //等待系統時鐘設置成功 0x08：PLL作為系統時鐘
}
}