STM32 CAN濾波器設置 Identifier filter

對照下表：

Extended Id濾波器設置(已驗證，只接受Receive_ID節點(diǎn)的數據)：

/* CAN filter init */ //設置成只能接受主節點(diǎn) Extended Id：01 的數據 reference manual p557
CAN_FilterInitStructure.CAN_FilterNumber=0;
CAN_FilterInitStructure.CAN_FilterMode=CAN_FilterMode_IdMask;
//CAN_FilterInitStructure.CAN_FilterMode=CAN_FilterMode_IdList;//###########################################
CAN_FilterInitStructure.CAN_FilterScale=CAN_FilterScale_32bit;
CAN_FilterInitStructure.CAN_FilterIdHigh=(((u32)Receive_ID<<3)&0xFFFF0000)>>16;
CAN_FilterInitStructure.CAN_FilterIdLow=(((u32)Receive_ID<<3)|CAN_ID_EXT|CAN_RTR_DATA)&0xFFFF;
CAN_FilterInitStructure.CAN_FilterMaskIdHigh=0xFFFF;
CAN_FilterInitStructure.CAN_FilterMaskIdLow=0xFFFF; // 1 :must match” or 0: as “don’t care
CAN_FilterInitStructure.CAN_FilterFIFOAssignment=0;
CAN_FilterInitStructure.CAN_FilterActivation=ENABLE;
CAN_FilterInit(&CAN_FilterInitStructure);

Standard Id濾波器設置：

CAN_FilterMaskId 位的含義是

Mask
Each bit of the register specifies whether the bit of the associated identifier register must
match with the corresponding bit of the expected identifier or not.
0: Don’t care, the bit is not used for the comparison
1: Must match, the bit of the incoming identifier must have the same level has specified in
the corresponding identifier register of the filter.

我們這里全部設置成1 ，也就是只接受CAN_Filter中設置的節點(diǎn)的數據